Glossary entry

English term or phrase:

warm-hold

Portuguese translation:

pré-aquecimento

    The asker opted for community grading. The question was closed on 2018-04-29 14:54:08 based on peer agreement (or, if there were too few peer comments, asker preference.)
Apr 26, 2018 11:11
6 yrs ago
4 viewers *
English term

warm-hold

English to Portuguese Tech/Engineering Engineering (general) engine
Start the engine.
if it is expected that warm-hold should be active, check conditions for warm-hold activation before fault tracing further.
'Conditions not being met' as a result of a system drain activation attempt is an indication that system drainage is not possible due to conditions not being met. This can be the case if pressure has not been built up in the system. Pressure must have been built up in the system during the current drive cycle in order for the system drainage function to be available.
'EGR differential pressure sensor' is connected to a specially-shaped tube, which the recirculated exhaust gas flows through. The EGR flow rate (mass flow) is calculated by the engine control unit based on the value it receives from the differential pressure sensor, along with the values from the boost pressure sensor and the EGR temperture sensor.
'SET' not pressed
(Prerequisite: Engine oil temperature must be above 55癈 (131癋)).
1. Depress and release the pedal.
A fault exists in the thermal switch circuit
A frozen cycle is an event in which the last driving cycle did not conclude with a completed system drain and the exhaust temperature sensor detects a temperature of -10癈 (14癋) or less at start-up. This implies that freezing conditions were encountered while there was diesel exhaust fluid within the system.
A hot engine and/or fluids can damage test equipment and can cause personal injury due to burns.
A. Engine Exhaust Gas Temperature- Temperature of the exhaust as it enters the DPF assembly.
ABS must not be active (this signal cannot be read from the engine ECU.Check that there are no fault codes in the ABS system).
AC Fan Override Time
AC pressure switch input to VECU active
AHI Diagnostic Test Executed, OK
AHI Diagnostic Test Not Executed
AHI Injection Demanded, OK
AHI Injection Not Demanded
AT Regeneration or Periodic Heat Mode Active
Abnormal frequency, pulse width, or period
Abnormal update rate
Abnormally large variations
Accelerator Pedal Demand Applied
Accelerator Pedal Demand Not Applied, OK

Proposed translations

8 mins
Selected

pré-aquecimento

sugestão.
Something went wrong...
4 KudoZ points awarded for this answer. Comment: "obrigada. Soou melhor no contexto"
+1
57 mins
English term (edited): warm-hold

função/recurso manter aquecimento


https://www.bobistheoilguy.com/forums/ubbthreads.php/topics/...
Volvo has a "warm hold" feature for both maintaining heat at idle and warming a cold engine. It somehow uses the engine brake (after a couple minutes idle) to put a load on the engine and spools up the turbo.
Peer comment(s):

agree Paulinho Fonseca
8 mins
Obrigado, Paulinho!
Something went wrong...
1 hr

aquecimento

Something went wrong...
Term search
  • All of ProZ.com
  • Term search
  • Jobs
  • Forums
  • Multiple search